6
ENGLISH
(Original instructions)
u
Have defective cords replaced immediately.
u
Do not expose the charger to water.
u
Do not open the charger.
u
Do not probe the charger.
$
The charger is intended for indoor use only.
+
Read the instruction manual before use.
Electrical safety
#
Your charger is double insulated; therefore no
earth wire is required. Always check that the
mains voltage corresponds to the voltage on the
rating plate. Never attempt to replace the charger
unit with a regular mains plug.
u
If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised BLACK+DECKER Service
Center in order to avoid a hazard.
Features
This tool includes some or all of the following features.
1. Trigger
2. Trigger lock-off button
3. Depth adjustment wheel
4. Contact trip
5. Sliding magazine
6. Magazine latch
7. Battery (not supplied)
8. Battery release button
Assembly
Warning!
Before assembly, make sure that the tool is
switched off and remove the battery.
Charging the battery (fig. A) (not supplied)
The battery needs to be charged before first use and whenev
-
er it fails to produce sufficient power on jobs that were easily
done before. The battery may become warm while charging;
this is normal and does not indicate a problem.
Warning!
Do not charge the battery at ambient temperatures
below 10 °C or above 40 °C. Recommended charging tem
-
perature: approx. 24 °C.
Note:
The charger will not charge a battery if the cell
temperature is below approximately 10 °C or above 40 °C.
The battery should be left in the charger and the charger
will begin to charge automatically when the cell temperature
warms up or cools down.
u
To charge the battery (7) (not supplied), insert the USB
charger (9) (not supplied).
u
Connect the USB charger (9) to a power source.
The charging indicator will blink. As the battery charges,
the state of charge LEDs will illuminate. The illuminated
LED(s) indicate the state of charge of the pack. The blink
-
ing LED indicates the next level of charge in progress. The
state of charge button is disabled during charging only.
u
The completion of charge is indicated by all four LEDs
turning off. Pressing the state of charge indicator button
will illuminate all four LEDs. The battery is fully charged
and may be used at this time or left on the charger
u
The charger and the battery can be left connected indefi
-
nitely.
u
Charge discharged batteries within 1 week. Battery life will
be greatly diminished if stored in a discharged state.
State of charge indicator
The BLACK+DECKER battery is equipped with a state of
charge button with a four LED display.
The state of charge is an indication of approximate levels of
charge remaining in the battery according to the following
indicators:
96 - 100% charged
76 - 95%
51 - 75%
26 - 50%
Pack needs to be charged
Note:
The state of charge LED will only display once the state
of charge button is pressed.
Fitting and removing the battery (fig. B) (not sup-
plied)
u
Make certain the trigger lock-off (2) is in the locked posi
-
tion before removing or installing the battery.
Summary of Contents for BDT12
