Black+Decker EVO185H2, Manual

7

ENGLISH

(Original instructions)

Electrical safety

Additional safety instructions for batteries and 

chargers

Batteries

  Never attempt to open for any reason.

  Do not expose the battery to water.

  Do not store in locations where the temperature may 

exceed 40 °C.

  Charge only at ambient temperatures between 10 °C and 

40 °C.

  Charge only using the charger provided with the tool.

  When disposing of batteries, follow the instructions given 

in the section "Protecting the environment".

p

Do not attempt to charge damaged batteries.

Chargers

  Use your Black + Decker charger only to charge the bat-

tery in the tool with which it was supplied. Other batteries 

  Never attempt to charge non-rechargeable batteries.

  Have defective cords replaced immediately.

  Do not expose the charger to water.

  Do not open the charger.

  Do not probe the charger.

$

The charger is intended for indoor use only.

+

Read the instruction manual before use.

Electrical safety

#

Your charger is double insulated; therefore no 

earth wire is required. Always check that the 

mains voltage corresponds to the voltage on the 

rating plate. Never attempt to replace the charger 

unit with a regular mains plug.

  If the supply cord is damaged, it must be replaced by the 

manufacturer or an authorised Black + Decker Service 

Centre in order to avoid a hazard.

Features

This tool includes some or all of the following features.

1. Variable speed switch 

3. Head release button 

4. Bit holder 

5. Battery 

7. Hammer drill head

10. LED work light

11. Charging indicator

12. Charger 

13. Speed selector

14. Clutch marking

Assembly

Warning! Before assembly, remove the battery from the tool.

tool. Slide the battery into the receptacle and push until 

the battery snaps into place.

the same time pulling the battery out of the receptacle.

Warning!

heads. Moving parts may become hot during use.

the centre position.

  To remove a tool head, depress the head release button 

(3) and take the head off the tool.

push it onto the tool until it snaps into place.

Fitting and removing a drill bit or screwdriver bit

allow for an easy exchange of bits.

the centre position.

one hand while holding the rear part with the other.

clockwise with one hand while holding the rear part with 

the other.

  To remove the screwdriver bit from the bit holder, lift the bit 

from the recess.