7
6
3. To turn off the 120 Volt AC Outlet and the two USB Power Ports, press the
Translucent Inverter/USB Power Button again (the Inverter Power/Fault Indicator
will turn off).
Periodically press the Battery Power Level Button to check the battery status. (When
all three battery status LEDs light, it indicates a full battery. Only one red battery status
indicator light indicates that the unit needs to be recharged.)
AREA LIGHT
The built-in 2-LED area light located in the front of the unit is controlled by the LED
Light Power Button on the front panel (refer to the Features section to locate). Press
the LED Light Power Button once to turn the light on. Press the LED Light Power
Button again to turn the area light off. Make sure the area light and the unit are turned
off when the unit is being recharged or stored.
Periodically press the battery power level pushbutton to check the battery status.
(When all three battery status LED light, it indicates a full battery. Only one red battery
status indicator light indicates that the unit needs to be recharged.)
TROUBLESHOOTING
Problem
Possible Solution
Unit will not
charge
• Make sure all power switches are turned off.
• Make sure a suitable gauge extension cord is properly
connected to both the unit and a functioning AC outlet.
Unit fails to
Jump-Start
• Make sure the unit’s power switch has been turned on.
• Make sure a proper polarity cable connection has been
established.
• Check that unit has a full charge. Recharge the unit if
necessary.
Portable
Compressor will
not inflate
• Make sure the Compressor Power Switch has been
turned on.
• Make sure the Sure Fit
®
nozzle connector is securely
screwed on to the valve stem when attempting to inflate
tires; or that the nozzle adapter is securely screwed into
the Sure Fit
®
nozzle connector and is inserted properly
into the item to be inflated on all other inflatables.
• The compressor may be overheated. Turn the compressor
off. Restart after a cooling down period of approximately
30 minutes.
• Check that the unit has a full charge. Recharge the unit
if necessary.
LED Area Light
does not come on
• Make sure the LED Area Light ON/OFF button is in the
ON position
• Check that unit has a full charge. Recharge the unit if
necessary.
Specific Inverter Problems and Possible Solutions
When the 120V AC Outlet and/or either of the USB Charging Ports are in use, the
unit monitors for the following fault conditions: thermal fault, low and high battery
voltage fault, overload and short circuit (refer to the “Protective Features” section).
If a fault condition exists in the AC Outlet or either of the USB Charging Ports, the
Inverter Power/Fault Indicator will flash and the 120 Volt AC Outlet and the dual
USB Charging Ports will all automatically shut down. Should this occur:
1. Disconnect all appliances from the unit and make sure the unit's Translucent
Inverter/USB Power Button has been pressed to turn the inverter functions off.
2. Allow the unit to cool down for several minutes before attempting to use either
the 120 Volt AC Outlet or USB Charging Ports again.
3. Make sure the appliance cords and plugs are not damaged.
4. Assure there is adequate ventilation around the unit before proceeding.
When Using the 120V AC Outlet
• Make sure the Translucent Inverter/USB Power Button is in the ON position.
• Ensure that the wattage of the equipment plugged into the 120 Volt AC Outlet
does not exceed 200 watts continuous.
• Make sure you have followed all the steps in the "Using the 120 Volt AC Outlet
and USB Charging Ports" section carefully.
• Refer to the “Specific Safety Instruction for Inverters” section.
• Make sure the USB Charging Ports are not in fault condition as the both the
120V AC Outlet and the dual USB Charging Ports will shut down simultaneously.
• Check that unit has a full charge. Recharge unit if necessary.
When Using the USB Charging Ports
• Make sure that the total draw of
all
USB devices plugged into the USB Charging
Ports does not exceed 2.1A.
• Make sure you have followed all the steps in the "Using the 120 Volt AC Outlet
and USB Charging Ports" section carefully.
• Refer to the “Specific Safety Instruction for USB Charging Ports” section.
• Some USB-powered household electronics will not operate with this type of
USB Charging Port. Check the manual of the corresponding electronic device to
confirm that it can be used with this type of USB Charging Port.
• If an individual USB device is within specifications and the fault occurs, have the
USB device checked for malfunction and do not continue to use it with these
USB charging ports.
CARE AND MAINTENANCE
All batteries lose energy from self-discharge over time and more rapidly at higher
temperatures. When the unit is not in use, we recommend that the battery is charged
at least every 30 days.
Never submerge the unit in water. If the unit gets dirty, gently clean the outer surfaces
of the unit with a soft cloth moistened with a mild solution of water and detergent.
There are no user-replaceable parts. Periodically inspect the condition of adapters,
connectors and wires. Contact manufacturer to replace any components that have
become worn or broken.
Battery replacement/disposal
BATTERY REPLACEMENT
The battery should last the service life of the unit. Service life is dependent on a
number of factors including but not limited to the number of recharge cycles, and
proper care and maintenance of the battery by the end user. Contact manufacturer for
any information you may need.
SAFE BATTERY DISPOSAL
Contains a maintenance-free, sealed, non-spillable, lead acid
battery, which must be disposed of properly. Recycling is
required. Failure to comply with local, state and federal
regulations can result in fines, or imprisonment.
Please recycle.
WARNINGS:
• Do not dispose of the battery in fire as this may result in an explosion.
• Before disposing of the battery, protect exposed terminals with heavy-duty electrical
tape to prevent shorting (shorting can result in injury or fire).
• Do not expose battery to fire or intense heat as it may explode.
ACCESSORIES
Recommended accessories for use with this unit may be available from the
manufacturer. If you need assistance regarding accessories, please contact the
manufacturer at 1-877-571-2391.
WARNING:
The use of any accessory not recommended for use with this appliance
could be hazardous.
SERVICE INFORMATION
Whether you need technical advice, repair, or genuine factory replacement parts,
contact the manufacturer at 1-877-571-2391.
FULL ONE-YEAR HOME USE WARRANTY
The manufacturer warrants this product against defects in materials and workmanship
for a period of ONE (1) YEAR from the date of retail purchase by the original end-user
purchaser (“Warranty Period”).
If there is a defect and a valid claim is received within the Warranty Period, the
defective product can be replaced or repaired in the following ways: (1) Return the
product to the manufacturer for repair or replacement at manufacturer’s option.
Proof of purchase may be required by manufacturer. (2) Return the product to the
retailer where product was purchased for an exchange (provided that the store is a
participating retailer). Returns to retailer should be made within the time period of the
retailer’s return policy for exchanges only (usually 30 to 90 days after the sale). Proof
of purchase may be required. Please check with the retailer for their specific return
policy regarding returns that are beyond the time set for exchanges.
This warranty does not apply to accessories, bulbs, fuses and batteries; defects
resulting from normal wear and tear, accidents; damages sustained during shipping;
alterations; unauthorized use or repair; neglect, misuse, abuse; and failure to follow
instructions for care and maintenance for the product.
This warranty gives you, the original retail purchaser, specific legal rights and you may
have other rights which vary from state to state or province to province. This product
is not intended for commercial use.
Please complete the Product Registration Card and return within 30 days from
purchase of the product to: Baccus Global LLC, One City Centre, 1 North Federal
Highway, Suite 200, Boca Raton, FL 33432.
Baccus Global LLC, toll-free number:
1-877-571-2391.
SPECIFICATIONS
Boost Ampere:
12V DC, 750A peak battery, 375A instantaneous
Battery Type:
Maintenance-free, sealed lead acid, 12V DC
AC Input:
120V AC, 60Hz, 13W
Area Light:
2 white LED
AC Outlet:
120V AC, 60Hz, 200W
USB Ports:
2.1A, 5V DC each
Compressor Maximum
Pressure:
120 PSI
Sure Fit
®
is a registered trademark owned by Baccus Global, LLC.
Imported by Baccus Global LLC,
One City Centre, 1 North Federal Highway, Suite 200, Boca Raton, FL 33432
www.Baccusglobal.com 1-877-571-2391
Número de catálogo JS75C2PB
PUENTE AUXILIAR DE ARRANQUE DE
350A CON COMPRESOR
MANUAL DE INSTRUCCIONES
CONSERVE ESTE MANUAL PARA FUTURAS CONSULTAS.
Nº de Catálogo:
JS75C2PB
SD061418
Derechos Reservados © 2018 Baccus Global LLC
¡Gracias por elegir Black & Decker!
Visite www.Baccusglobal.com para registrar su nuevo producto.
LEA EL MANUAL ANTES DE DEVOLVER
ESTE PRODUCTO POR CUALQUIER MOTIVO:
Si tiene una consulta o algún inconveniente con su producto, visite
HTTP://WWW.BACCUSGLOBAL.COM
para obtener respuestas instantáneas las 24 horas del día.
Si no encuentra la respuesta o no tiene acceso a Internet, llame al 1-877-571-2391 de
Lunes a Viernes de 9 a.m. a 5 p.m. hora del este para hablar con un agente.
Cuando llame, tenga a mano el número de catálogo.
BC
