12
RADIAL ROCKET Item code: BH155
.
Instruction Manual
After the epoxy has fully cured, remove the masking
tape or T-pins used to hold the stabilizer in place and
carefully inspect the glue joints. Use more epoxy to fill
in any gaps that may exits that were not filled previ
-
ously and clean up the excess using a paper towel and
rubbing alcohol.
ELEVATOR PUSHROD INSTALLATION
1)
Using pliers, carefully make a 90 degree bend
down at the mark made. Cut off the excess wire, leaving
about 6mm beyond the blend.
2)
Insert the 90 degree bend down through the
hole in the servo arm. Install one nylon snap keeper
over the wire to secure it to the arm. Install the servo
arm retaining screw.
VII. RUDDER INSTALLATION
Rudder install as same as the way of aileron.
Top side
C/A glue.
M2 Lock nut
M2
Elevator pushrod
Bottom side.
Silicone Tube
RUDDER CONTROL HORN INSTALLATION
Rudder control horn install as same as method of
elevator control horn.
Cut. Secure.
Flaslink
Pushrod wire
servo arm
Snap keeper
Top side
Elevator pushrod
Elevator servo
Secure.
Bend
Cut.