P47-THUNDERBOLT
.
Item code: BH36-B.
Instruction Manual
11
3)
Draw a center line onto the horizontal stabilizer.
Then put the horizontal into the fuselage.
Push in
B
B
A
A
4)
Check the fit of the horizontal stabilizer in its
slot. Make sure the horizontal stabilizer is square and
centered to the fuselage by taking measurements, but
don’t glue anything yet.
5)
With the horizontal stabilizer correctly aligned,
mark the shape of the fuselage on the top and the
bottom of the tail plane using a water soluble / non
permanent felt-tip pen.
6)
Remove the stabilizer. Using a modeling knife
and ruler
CAREFULLY
cut 1mm
inside
the marked
lines. Remove the covering from the top and the
bottom of the tail plane.
Make sure you only cut with enough pressure to only
cut through the film and not the wood. Cutting into
the balsa structure may weaken it. This could lead to
possible failure during flight.
1. ELEVATOR CONTROL HORN
INSTALLATION
Mark line
Top side
Center line
Trim the covering
from the tail slots.
Top side and
bottom side.
Remove
the covering.
Bottom side.
control horn
1. A+B Epoxy glue
2. Push in
Elevator control horn install as same as the way of
aileron control horn. Please see pictures below.
Check to mark sure the wing and stabilizer are
paralell. If they are not, lightly sand the opening
in the fuselage for the stabilizer until the stabilizer
is paralell to the wing, but don’t glue anything yet.
A
A
A = A
