MODULAR GRILLGUARD FOR DODGE RAM MEGA CAB 1500/2500/3500 06-08
Page 3 of 5
INSTALLATION INSTRUCTIONS
1
ST
STAGE
1
Set
Grille Guard
1
Set
Brackets(left & right, when sitting in the car)
4
pc
7/16 x 1-1/4” Hex Bolts
4
pc
7/16 Nylon Lock Nuts
8
pc
7/16 Flat Washers
8
pc
M10 Flat Washers
8 pc M10 Lock Washer
2
pc
M6 x 25 Allen Bolts
2
pc
M6 Lock Nuts
4
pc
6mm Flat Washers
8 pc M10*45 Hex Head Bolt
8 pc M10 Hex Nut
Instructions:
INSTALLING FRAME BRACKETS AND FRONT BAR
1
、
REMOVE TOW HOOKS FROM FRONT BUMPER. (REMOVE TEMPORARY
2
、
ATTACHE PASSENGER SIDE FRAME BRACKET BETWEN FRAME AND TOW HOOK
PASSENGER SIDE SHOWN
）
USING THE FACTORY BOLT.
（
NOTE
：
RUN ONE OF
THE 3/8 x 1-3/4” HEX BOLT FROM BEHIND OF THE FRAME AND THE 3/8 NYLON
LOCK JAM NUT ON THE BOTTOM LEFT CORNER ONLY, THIS WILL GIVE YOU
CLEARANCE ON THE CORNER. SNUG TIGHT ONLY
。
3
、
REPEAT STEP 1 AND 2 ON DRIVER SIDE
4
、
LINE UP THE TWO HOLES ON THE LOWER PORTION OF THE BAR WITH THE TWO
OF THE HOLES IN THE FRAME BRACKETS (INNER EDGE) ATTACH FRONT BAR
USING THE 7/16 x 1-1/4 HEX BOLTS, 7/16 NYLON LOCK NUTS AND 7/16 FLAT
WASHERS. SNUG TIGHT ONLY.
INSTRUCTION TOP SUPPORT BRACKERTS
1
、
OPEN HOOD
，
ATTACH TOP SUPPORT BARACKET ON TOP OF THE CROSS FRAME
HIGHER END AS SHOWN) USING THE EXISTING BOLT. SNUG TIGHT ONLY.
LOWER END OF SUPPORT BRACKET WILL LINE UP UNDER CENTER FLANCE OF
FRONT BAR , ATTACH USING THE 1/4 SCREWS AND 1/4 NYLON LOCK NUT.
2
、
MAKE SURE VEHICLE HOOD WILL CLEAR WHEN CLOSING HOOD
3
、
PROCEED TO TIGHTEN ALL FASTERNERS
2pcs 7/16 x 1-1/4” Hex Bolts
4pcs 7/16 Flat Washers
2pcs 7/16 Nylon Lock Nuts
1pc M6 x 25 Allen Bolts
2pcs 6mm Flat Washers
1pc M6 Lock Nuts
