12
OPERATING INSTRUCTIONS
Factory Fitted Items
1. Pump air filter
2. Pump oil breather
3. Pump filled with oil, check pump oil level, Pic 5A and 5B
Pump Oil, Pic. 5A and 5B
Warning: Your air compressor pump IS FILLED with OIL!
Your pump is factory filled with oil, however please check
the oil sight glass to ensure the oil level is correct.
To check the pump oil level:
1. Always check the oil level when the air compressor is on
flat and level ground.
2. Look at the sight glass and ensure the oil is above the
red dot on the sight glass, as per the “OIL LEVEL GAUGE”
label, see Pic. 5A and 5B.
To add pump oil, if required, additional oil not
included:
1. Make sure air compressor is level
2. Clean the oil breather area of any dirt and debris
3. Remove oil breather, see Pic 5B.
4. Add oil, SAE30 to at least the top of the red dot, see Pic.
5A and 5B.
5. Oil level will take about 1 minute to drain down and
settle.
6. Check oil level in sight glass, see Pic. 5A and 5B. Re-
check and top up if required, until level is correct.
7. Replace oil breather, and wipe area clean of any excess
oil.
To remove pump oil, if required:
1. Make sure air compressor is level
2. Clean the oil drain bolt area of any dirt and debris
3. Loosen and remove oil drain bolt, see Pic 5B.
4. Drain oil, until the oil drops to least the top of the red dot,
see Pic. 5A and 5B.
5. Replace and tighten oil drain bolt, see Pic 5B.
6. Check oil level in sight glass, see Pic. 5A and 5B.
7. If needed repeat steps 3 to 6, until level is correct.
8. Tighten oil drain bolt and wipe area clean of any
excess oil.
PIC. 5A
Oil drain bolt
Oil sight glass
Oil breather
PIC. 5B
