ENG
LIS
H
ENG
LIS
H
|
Owner’s Manual
blackstoneproducts.com/support
ENG
LIS
H
one half turn
❸
❶
❷
❹
STEP 01
In order for the ignitor
button to work properly, ensure that
the battery is installed correctly.
STEP 02
❶
Ensure that the control knob is
turned to OFF.
!
WA R N I N G
Do not lean over the appli-
ance while lighting.
!
WA R N I N G
If ignition does NOT occur
in 5 seconds, turn burner
controls OFF, wait 5
minutes and repeat lighting
procedure.
If burner does not ignite with
open valve, gas will continue
to flow out of burner and
could accidentally/inad-
vertently ignite with risk of
injury.
IGNITION |
BATTERY POWERED
PROPANE BURNER OPERATION
For proper ignition and operation of the appliance follow the steps below.
STEP 03
Ensure that the LPG
tank is properly connected to
the unit. Turn gas ON at the LPG
cylinder by slowly turning the OPD
handwheel halfway.
STEP 04
❷
Push and hold the ignitor button.
❸
Push and turn the control knob counter-clockwise to HIGH.
(Release the ignitor button when the burner lights.)
❹
Adjust the temperature to desired level.
Ignition | Battery Powered
ENG
LIS
H
3-7mm
TROUBLESHOOTING
Visit
BLACKSTONEPRODUCTS.COM/SUPPORT
for additional
troubleshooting.
If you
CAN
ignite your griddle with a match
POSSIBLE CAUSES
SOLUTION
01. Dead battery or no battery.
Replace with new battery.
02. Battery installed incorrectly.
Ensure that the battery is installed nega-
tive end first.
03. Ignitor wire misaligned.
Ensure that the ignition needle is posi-
tioned 1/8" to 1/4" away from the burner
tube, positioned above a burner hole.
04. Damage to the ignition system.
Contact customer service for replace-
ment parts.
If you
CAN NOT
ignite your griddle with a match
POSSIBLE CAUSES
SOLUTION
05. Burner tubes are not receiving fuel.
Please reference the Gas Flow section of
the Troubleshooting Chapter.
SYMPTOMS
01. Burner will not Light with ignition system
02. Pressing the ignitor button does not result in a clicking sound
If ignition does not occur in 5 seconds, turn the burner controls off, wait 5
minutes and repeat the lighting procedure.
If this does not work, to determine the cause, please try to ignite your griddle
with a match. (Please reference the Match Lighting Instructions in the
Cleaning the Burner Assembly section of the Care & Maintenance chapter.)
Insert one (1) AA battery (not
included) into the battery socket
with the positive terminal facing
out, then screw on the ignitor
button until tight. Be careful to not
over tighten.
Ensure that the ignition needle is
positioned 3-7mm away from the
burner tube, positioned above a
burner hole.
Section 01
BATTERY POWERED IGNITION
Troubleshooting
15
Model 2086