ENG
LIS
H
ENG
LIS
H
|
Owner’s Manual
blackstoneproducts.com/support
ENG
LIS
H
Section 02
CLEANING THE BURNER ASSEMBLY
Unit burners vary, however these instructions apply to all units. Clean
burner assembly and check burner for damage. If any large cracks or
holes are found, replace burner.
STEP 01
Ensure that the gas is turned OFF at control knobs and gas supply.
Remove the cooking top.
STEP 02
Carefully detach and
remove the burner.
STEP 03
Run a narrow bottle
brush through each burner tube
several times. (DO NOT use
wire brushes)
Additional Methods Include:
Run a stiff wire bent into a small
hook through each burner tube
several times.
Use an air hose to force air into
burner tube and out burner ports.
Check that air blows through each
hole. (Wear eye protection)
STEP 05
Clean any blocked ports
with stiff wire such as an open
paper clip. Then, carefully replace
burners and reattach.
VERY IMPORTANT:
Burner
tubes must be reengaged with the
valve openings.
STEP 04
Brush entire outer
surface of burner to remove grime.
!
WA R N I N G
Ensure that the fuel nozzle
is housed within the burner
opening.
VIDEO TUTORIAL
How to Clean Your Burner Tube
| Blackstone Griddle
youtube.com/
watch?v=xKQTCrFCzf8
Care & Maintenance
ENG
LIS
H
BURNER FLAME CHECK
Always check burner flame
before use.
STEP 01
Light burners and rotate
knobs from high to low. When knob
is at high, flames should be larger
than when knob is at low.
STEP 02
Perform burner flame
check by looking below cooking
top on the side of unit to view
burners below.
If there is a sudden drop or low
flame issue, please reference the
Troubleshooting chapter.
BURNER MAINTENANCE
In most circumstances, burning
residue off after cooking will keep
burner clean.
• Ensure that the flow of combus-
tion and ventilation air is
not obstructed.
• Burner should be removed and
cleaned annually or whenever
heavy build-up or insects/insect
nests are found in order to ensure
that there is no blockage in the
burner portholes or venturi tubes.
• Use pipe cleaner to clear obstruc-
tions. A wire brush may be used to
remove corrosion from the burner
surfaces.
MATCH LIGHTING
INSTRUCTIONS
Before beginning, check for gas
leaks. (Please reference the
Leak Test Instructions in the Fuel
chapter.)
STEP 01
Ensure control knob is in
OFF position.
STEP 02
Remove cooking top.
STEP 03
Light a match (or long
lighter) no shorter than 11 inches
long. Place the flame on the right or
left side of the burner.
STEP 04
Push in and turn the
control knob to the HIGH position.
Ensure burner lights and stays lit.
Healthy flames might have a few
flickers of yellow color
❶
, then a
dark blue color
❷
, followed by a
vibrant blue by the burner tube
❸
.
❶
❷
❸
!
WA R N I N G
A clogged burner tube can
lead to a fire beneath the
appliance.
Care & Maintenance
21
Model 2086
