Part
III:
Operating
the
Wood Chipper
PART IV: Operating the Wood Chipper
It may be helpful to better familiarize yourself with the features of your Wood Chipper before
beginning the steps outlined in this chapter.
A.
Read and understand all instructions, safety precautions, and/or warnings listed in
“PART I: General Safety Rules” before operating the WOOD CHIPPER. If any doubt
or question arises about the correct or safe method of performing anything found in this
manual, please contact the dealers in your area.
B.
When operating the Wood Chipper, make sure you are standing in the safe operating
area (OPERATOR ZONE). You must stay in the safe operating area at all times when
the ram is in motion (whether extending or retracting). Never place any part of your
body into a position that causes an unsafe operating condition.
C.
Before loading and operating the Wood Chipper, always wear protective gear,
including safety goggles, hearing protection, tight-fitting gloves without draw strings or
loose cuffs, and steel-toed shoes.
D.
Knowing the correct and incorrect methods of Chipping woods. Never using an
incorrect or unsafe method.
Starting
1.
Position your Wood Chipper on flat, dry ground, and then stop the front wheel with
brake, make sure the machine cannot be moved.
2.
Make sure the fuel shut-
off valve is in the “ON” position.
3.
Move the choke control lever to the “CHOKE” position (should only be needed if the
engine is cold).
4.
Move the throttle control lever to the “FAST” position.
5.
Recoil Start: Turn the Ignition Switch to the “On” position. Grasp the recoil starter
handle and slowly pull until you feel resistance. Let the cord retract a little bit then pull
the cord rapidly to start the engine. One or two pulls usually starts the engine.
6.
Electric Start: Turn and hold the Key in the start position until Engine starts then let the
Key return to run position.
7.
Move the choke control lever (if used for cold engine) slowly back to
the “RUN” position
when the engine is running well.
8.
If the Wood Chipper has not been running (cold engine), warm up the engine by running
the engine at half throttle for 3 to 4 minutes, then advance the engine throttle control to
the maximum speed.
WARNING
Summary of Contents for GTE-2000
Page 1: ...GTE 2000 WOOD CHIPPER Instruction Manual Table of Contents ...
Page 3: ...Part I GeneralSafety Rules 2 Safety Labels Found on Your Unit ...
Page 16: ...Part II Setting Up The Log Splitter 15 tighten the plate again using the four bolts ...
Page 24: ...x Part II Setting Up The Log Splitter 23 Fig 63 Open choke and fuel shut off Choke Fuel tap ...
