10
Problem
Alarm will not go into Code Learning
Mode.
Alarm will not rearm or will not pas-
sively arm.
Flashing light output does not work.
Door locks do not lock/unlock correct-
ly, or action is reversed
Probable Cause
RED or YELLOW wire not connected
to the correct power source. Code
Learning sequence performed too slow-
ly.
Door is open,VIOLET wire is connected
to positive voltage, GREEN wire is con-
nected to ground, main YELLOW wire
(ignition wire) is connected to +12V, or
door pin switch is bad.
Bad connection on WHITE wire or the
output polarity is wrong for the circuit
being driven.
Defective GREEN or BLUE wire from
door lock connector plug, GREEN and
BLUE wires reversed, or wrong door
lock wiring diagram used.
Suggested Correction
RED wire should connect directly to
the battery. Connect YELLOW wire to
true ignition wire (NOT AT FUSE
BLOCK). Perform Code Learning
sequence faster.
Check VIOLET and GREEN wires with
doors closed and open, and YELLOW
wire with ignition switch off and on for
voltage changes. Repair and/or rewire as
needed.
Check WHITE wire. Connect a SPDT
relay to this wire and apply the opposite
polarity to the circuit being driven.
Check GREEN and BLUE wires on door
lock connector plug, Check vehicle’s
door lock system for method of opera-
tion. Reverse wiring to door relays.
SECURITY SYSTEM TROUBLESHOOTING
STATUS INDICATOR (LED) FUNCTIONS
On Solid = Valet Mode
Slow Flash = System Armed
Rapid Flash = Passive Arming
Flash 2x = Remote Start
Flash 3x = Stop and Go Mode
Flash 4x = Cold Start Mode
PARKING LIGHTS FUNCTIONS
On Solid = Vehicle Remote Starting
Flash 1x = Doors Locked
Flash 2x = Doors Unlocked
Flash 3x = Open Zone Indication (after arming)
Flash 4x = Remote Starting Failed
Flash 5x = Auto Cold Start Engaged
