Black Widow Security 6150, Installation Manual

5

Programmable Features

1. Arming Mode. Select between manual arm-
ing (Active) or automatic arming (Passive).
2. Auto Rearm.Automatically rearms the sys-
tem in case of accidental disarming.The system
must be armed for at least 10 seconds before
disarming, and the hood/trunk must not be
opened or Auto Rearm will be bypassed.
3. Arming Chirps. Select Normal or Silent
Arming.
4. Ignition Locking / Override Code Set.
Automatically locks the doors when the igni-
tion is turned on. The system will not lock the
doors if any door is open when the ignition is
turned on. Pressing Button 3 during this step
enters the Override Code Set mode. Press the
valet switch the desired number of times from
1-15 to set the code.
5. Ignition Unlocking. Automatically unlocks
the doors when the ignition is turned off. Select
from all door unlock, driver's door only unlock,
or no unlock. (Note: Driver’s door only unlock
requires wiring the system for Passenger
Unlock. see Two Step Unlocking Diagrams.) 
6. Door Unlock Pulse - Single/Double. Selects
between a single pulse or a double pulse door
unlock output.
7. Door Lock Pulse Width. Selects between a
1-second and a 3-second output for vehicles
equipped with vacuum door locking systems.
8. Passive Locking. Selects whether or not the
system will automatically lock the doors with
Auto Rearm and Passive Arming.
9. Door Entry Delay with Passive Arming.
When selected, the door input trigger will be
delayed for 15 seconds, allowing access to the
emergency override switch. Only delays when
the system is armed passively.

10. Bad Zone Report. Siren will chirp 3 times if
any zone remains open 5 seconds after arming.
If vehicle has delayed dome light, program this
feature to OFF.
11. Auxiliary 2 Auto Activate on Arming.When
selected, the Auxiliary 2 output will pulse upon
system arming to activate accessory items
when the system is armed.
12. Auxiliary Function I - Selectable for
Momentary,Timed, or Latched operation.
When Momentary operation is selected, the
system will provide an output for as long as the
Transmitter button is held.
When Latched operation is selected, the system
will provide an output that turns on when the
transmitter button is pressed and turns off
when the transmitter button is pressed again.
When Timed operation is selected, the system
will provide an output that turns on for 10 sec-
onds each time the transmitter button is
pressed. If the button is pressed again during
the 10 seconds, the output will turn off.
13. Auxiliary Function 2 - Selectable for
Momentary,Timed, or Latched operation.
14. Trunk Disarm Feature. When selected,
activating the Auxiliary 1 function to open the
trunk will automatically disarm the system.
15. Remote Start in Valet Mode. Determines if
the remote start feature will operate when the
alarm is set for valet mode.
16. Lock with Remote Start. Automatically
locks the doors after successfully remote start-
ing.
17. Lock with Remote Shutdown.
Automatically locks the doors 5 seconds after
the remote start is shut down.
18. Engine Run Time. Selects between 12 and
24 minute run cycle.