system is disarmed and rearmed.
OPTIONAL SECURE
OVERRIDE CODE
If your system was programmed to override
with a personal override code-pressing the
override switch from 1 to 15 times.
To disarm the system with your personal over-
ride code please use the following steps:
1. Open Door, Alarm system will trigger
2.Turn ignition key to on
3. Press the override switch to the selected
number of times and hold on the last one for
5 seconds until the alarm turns off.
Remote Start Operation
Important:
Only start the vehicle in a
well ventilated area. Do not use in a
closed garage or indoors. Be sure to
familiarize yourself with all features
prior to using this product.
REMOTE STARTING THE VEHICLE
To remote start the vehicle:
Press transmitter button 4 for 3 seconds.
• The parking lights turn on.
• Approximately 2 seconds later the
system will attempt to start the vehicle.
• Once the car has started, the heater or
air conditioner will turn on and run for
the pre-programmed time (15 or 25
minutes). If the engine fails to start on
the first attempt, it will repeat the
starting procedure 2 more times. If the
vehicle fails to start after a total of 3
times the system will shut down.
Driving vehicle after Remote Starting:
Unlock the door by pressing button 2* on
the remote transmitter. Enter vehicle, turn
ignition key to the on position (
Note
:
Do not
turn the key all the way to the start position as
you may damage the starter
).
Once the ignition key is turned to the on
position, press the brake pedal and shift the
car into the proper gear and you may now
drive the vehicle (
Note
:
If brake pedal is
pressed prior to turning on ignition, engine will
turn off
).
REMOTE ENGINE SHUTDOWN
If the vehicle has been remotely started and
you desire to turn the vehicle off, simply press
and hold button 4 on the remote transmitter
for three seconds. After the motor has
turned off the doors will relock*.
This feature
must be programmed during installation
.
AUTO COLD START
This feature allows the system to start and
run the vehicle every one or two hours
(selectable by your installer) for a period of
24 hours.This allows the engine to remain at
an operational temperature in extremely
cold weather.
Auto Cold Start must be enabled
during installation or it cannot be engaged
.
Engaging the Auto Cold Start feature:
To turn Auto Cold Start on:
1. Press and hold the brake pedal.
2. While holding the brake pedal down,
push the Valet switch and transmitter
button 2 for two seconds.
• The parking lights will flash four times
to indicate the Cold Start feature is
engaged.
3. Release the brake pedal.
4
*
Optional Feature
