2
SILENT LOCKING/UNLOCKING
If the optional Horn Honk feature is installed,
pressing transmitter buttons 1&2 together
provides one-time silent operation. The system
locks or unlocks the doors without horn
confirmation.
IGNITION CONTROLLED LOCKS
The ignition controlled locks feature
automatically locks the doors after turning on
the ignition, and unlocks when the ignition key
is turned off. This feature may also be
programmed for ignition lock without ignition
unlock, and off (no ignition control).
VALET MODE
When the system is placed into the Valet Mode
the remote start feature will be disabled.
However, the optional keyless entry and trunk
release features will still function if installed.
To enter mode:
1. Be sure the system is in unlock mode.
2. Turn ignition on.
3. Press and hold the valet switch for 5
seconds.
• The LED will turn on solid 5 seconds
after turning ignition off.
• The horn will honk 5 times.*
4. Turn ignition off.
To exit valet mode:
1. Be sure the system is in unlock mode.
2. Turn ignition on.
3. Press and hold the valet switch for 5
seconds.
• The LED will turn off.
• The horn will honk twice.*
4. Turn ignition off.
OPTIONAL TRUNK RELEASE
The activate the system’s auxiliary feature (or
trunk release) press button 2 for three
seconds. NOTE: the Trunk Release feature may
be programmed to activate with button 4
instead. See your dealer for more details.
CAR LOCATOR FEATURE
To activate the system’s car locator feature
press and hold button 4 for three seconds. The
parking lights will flash and the horn will honk
(optional) 5 times.
REMOTE START FEATURES
Important: Only start the vehicle in a well
ventilated area. Do not use in a closed garage
or indoors. Be sure to familiarize yourself with
all features prior to using the remote start.
REMOTE STARTING THE VEHICLE
To remote start the vehicle press button 3.
• The parking lights will flash 4 times then
remain on.
• The system will attempt to start.
• Once the car has started, the heater or air
conditioner will turn on and run for the
pre-programmed time. If the engine fails to
start on the first attempt, it will attempt to
start 2 more times. If the vehicle fails to
start after a total of 3 times the system
will shut down.
To drive the vehicle after Remote Starting:
Unlock the door by pressing button 2 on the
remote transmitter. Enter vehicle, turn
ignition key on position and press brake pedal
NOTE: Do not turn the key to the start position
as the engine is already running.
If brake pedal is pressed prior to turning on
ignition, engine will turn off.
REMOTE ENGINE SHUTDOWN
If the vehicle has been remotely started and
you desire to turn the vehicle off, simply press
and hold button 3 for 3 seconds.
BW651 final.qxd 10/18/2005 10:58 AM Page 2
