6
• EMPTY - Not used.
• BLUE WIRE - Unlock output (-) 500mA.
4-Pin Blue Connector:
Plug-in connector for
extended range receiver.
SYSTEM PROGRAMMING
Entering Programming
To enter System Programming:
1. Within 3 seconds, turn the ignition on, off,
on, off and leave on.
2. Press the valet switch.
• The parking lights will turn on.
• The horn will honk once (optional).
3. Press transmitter button corresponding to
the desired programming menu:
Button 1 = Menu 1
Button 2 = Menu 2
Button 3 = Menu 3
Button 4 = Menu 4
4. Press the valet switch the number times
equal to the Feature you want to change.
• The LED will flash, and the horn will honk
(optional) to indicate which feature step
is selected. (Example: step 2 = 2 flashes
and 2 honks.) The LED will continue
flashing the step number until another
step is chosen or ignition is turned off.
5. Press and hold the valet switch until the
parking lights flash and the horn honks the
number of times equal to the desired
operating mode for that feature, then
release the switch.
6. Press the valet switch to move to the next
feature, or repeat step 4 to change menus.
7. Turn off ignition to save changes.
Default Reset
Follow this procedure to set the Programming
Features to factory default settings.
NOTE: The system reset will clear changes
made to the Tach setting as well. After a system
reset, the Tach must be re-learned before the
remote starter will operate properly.
To reset all functions to their default settings:
1. Within 3 seconds, turn the ignition on, off,
on, off and leave on.
2. Press the valet switch.
• The parking lights will turn on.
• The horn will honk once (optional).
3. Press and hold the valet switch until the
parking lights flash and the horn honks
(optional) 3 times to confirm reset.
4. Turn ignition off.
Remote Start Programmable Features
Menu 1
1. Ignition Lock/Unlock. Controls the door
locks with the ignition. On/On mode- the
doors will automatically lock or unlock when
ignition is turned on and off. On/Off mode- the
doors will automatically lock with ignition, but
not unlock with ignition. Off mode- no ignition
control of door lock system.
2. Horn Output. The horn output may be
programmed to operate in one of three ways:
honks with the Car Finder and Panic features
only, honks with all features except start, or
honks with all features.
3. Door Lock/Unlock Pulse. Selects between
three door lock configurations: a .75-second
lock and two .75-second unlock pulses (for
some Japanese cars), a 3-second lock and
unlock pulse (for vacuum locks), or a .75-
second lock and unlock pulse (standard).
4. Short Unlock/Disarm Pulse. Some vehicles
require a shorter unlock/disarmpulse. For these
vehicles use the .125-second pulse.
Menu 2
1. Valet Mode Timing. Sets the length of time
the valet switch must be held in order to enter
the valet mode- either 15 or 5 seconds.
2. Parking Light Output. Selects one of three
BW651 final.qxd 10/18/2005 10:58 AM Page 6
