BEFORE INSTALLING THIS PRODUCT PLEASE READ THIS
INSTALLATION MANUAL THOROUGHLY!!
INSTALLATION
MANUAL
Before Installing:
• This product must be installed by qualified
personnel according to these instructions and and
observing all safety features.
• Before mounting the product check the possible
locations for the siren, LED and module before you
permanently install them
• Always look before drilling. Make sure you will not
cause damage to vehicle hoses, electrical looms or
physical damage to the vehicle.
• Program the Polarity Jumpers for Parking Lights &
Illuminated Entry Output as described on page(s).
• Check to see if the vehicle is equipped with any type
of factory security system.
• Verify with the customer the desired location for
the program switch and LED.
• Always use a multi-meter when verifying vehicle
wiring.
Hardware:
• Main unit
• 2 4-button, Remote transmitters with labeled
buttons for lock, unlock trunk release and option.
• Built-in relay for parking lights with polarity jumper
for +/- output
• Built-in relay for dome light with polarity jumper
for output
• Built-in relay for auxiliary output
• Built-in relay for starter defeat (normally closed)
• Built-in relays for door locks
• Plug-in connector for LED
• Plug-in connector for valet override switch
• Plug-in connector for shock sensor
• Plug-in connector for auxiliary sensor
• Standard siren
• Dual-zone plug-in shock sensor Part Kit:
• Main harness
• Plug-in LED
• Plug-in override switch
• 3-Pin door lock harness
• 2-wire starter defeat lead
• (2) Window stickers
1