5
DEFAULT RESET
To reset all programmable features to their
factory default settings:
1. Turn on ignition.
2. Within 5 seconds, press valet switch 5
times.
• The horn will provide a long chirp, to
indicate entering program mode.
3. Press transmitter button 3.The LED will
flash 3 times, pause then continue
flashing. All programmable features will
be reset to the default position.
ADDING / DELETING REMOTE
TRANSMITTERS
Adding new transmitters to the system will
automatically delete all other remotes that
were previously operating the system.
NOTE:
You must code all desired remotes
at this time.The unit can learn a maximum of
three transmitters.
To enter Code Learning Mode:
1. Turn ignition key on, off, on, off, on and
leave on within 5 seconds.The horn will
chirp (if installed) and the LED / parking
lights will flash once.
2. Press and hold valet switch for 3
seconds.The horn will chirp and the LED
/ parking lights will flash 3 times.
3. Release the program switch.
4. Program all desired remotes by pressing
button 1 on each of the transmitters.
The parking lights will flash after the
system has learned each remote control.
5. Turn ignition key off. Remotes are now
programmed to the system.
