7
To resume driver control:
1. Unlock the doors by pressing transmitter
button 2.
2. Turn on the ignition.
• The vehicle resumes driver control,
when the brake pedal is pressed.
AUTO COLD START
This feature allows the system to start and run
the vehicle every 1, 2, 4, or 12 hours (selectable
by your installer) in a 24 hour period.This
allows the engine to remain at an operational
temperature in extremely cold weather. Auto
Cold Start interval timing must be chosen
during installation.
Engaging the Auto Cold Start feature:
To turn Auto Cold Start on:
1. Press and hold the brake pedal.
2. Press and hold button 2 for level shift.
3. Press button 1.
4. Release the brake pedal.
• The vehicle will start and run the first
interval to confirm cold start activation.
Use the Remote Engine Shutdown procedure
before first run cycle is completed. The Auto
Cold Start feature will remain engaged and
start at the pre-programmed intervals.
NOTE: The Auto Cold Start feature is not
compatible with manual transmission vehicles.
Disengaging the Auto Cold Start feature:
The Auto Cold Start feature can be deactivated
by pressing the brake pedal.
SAFETY FEATURES
The System will not start the vehicle if the
brake pedal is pressed or the hood is open.
Also, if the brake is pressed or the hood is
opened while remote running, the remote start
will shut down.
MANUAL TRANSMISSION MODE
On manual transmission vehicles, the remote
start feature will not operate unless the proper
vehicle exit sequence is performed. This
operating mode protects against in-gear
starting but is not completely without risk.
Installation and safe use of the remote start
feature on a manual transmission vehicle is at
the sole risk of the vehicle’s owner, and the
manufacturer assumes no liability for
installation in manual transmission vehicles.
Manual Transmission Safe Mode Exit Sequence:
With the engine running and the parking brake
set, press the unlock button. Turn ignition off
(engine will stay running) and open the doors,
then exit the vehicle. When all doors are
closed, press lock button to turn off the engine
and arm the system. The system will be able to
remote start as long as the alarm is not
disarmed prior to remote starting.
NOTE: If the turbo timer feature is
programmed, the engine will not turn off until
the end of the turbo timer program cycle.
TURBO TIMER MODE
For vehicles equipped with a turbo-charged
engine, the optional turbo timer feature may be
programmed to run the engine at idle for an
additional period of time after the ignition is
turned off. The run-time may be programmed
for a 1, 3, or 6 minute cycle, allowing the turbo
proper time to cool down, extending its life.
To activate the Turbo Timer feature:
1. Make sure the engine is running.
2. Press button 2.
3. Turn ignition off.
• The engine will continue to run for 1, 3,
or 6 minutes.
4. Exit the vehicle.
7250 rev 2 9-23.qxd 9/24/2004 12:54 PM Page 7
