2
3 Channel Programmable Features:
Feature #
Button One=ON
Feature #
Button Two=OFF
(1)
Car Locator feature ON (parking
(1)
Car Locator feature OFF
lights stay on 30 sec. after disarm).
(2)
Single unlock pulse
(2)
Double unlock pulse
(3)
Red/White wire is 3rd. Channel output
(3)
Red/White wire is (-) horn output
(4)
Channel# 2 normal operation
(4)
Auto disarm when Ch.# 2 used
Default features are all ON.To change all features to default position enter program mode as
above and press both buttons 1&2 together until siren chirps.
duce a grounded output when system is
armed.
Flashing Parking Light Output:
Armed:
1 second pulsed,
Disarmed:
2-one
second pulses-, then output will latch on
for 30 seconds, or until ignition is turned
on, or system rearms.
System triggered:
1
second pulse on, 1 second off, repeated
for 45 seconds.
Dome Light Output
:
Output is identi-
cal to Flashing Parking Light Output.
Super Selective
Receiver Board:
The new receiver design allows for a
much narrower band width reception. It
rejects RF interference that causes incon-
sistent range in similar type products and
improves the range of transmission
between remote and receiver. Average
minimum range is 100’ although it is com-
mon to get between 150’-300’. Our
extended range model with windshield
mounted receiver allows for up to 500’ of
range.
Input Zone Out Feature:
If a door input, shock or sensor input
remains on for 4 consecutive cycles (45
seconds) that input will be ignored. If the
input returns to a non-triggered state for
30 seconds it will be monitored by the
system again.
PROGRAMMING FEATURES
3 CHANNEL SOFTWARE
UPDATE
All 3 channel platforms have been updated
with new programmable features!
Features that can be programmed are the
following:
1. Parking lights can be programmed to
not stay on after disarm (car locator func-
tion).
2. Double unlock pulses can be added.
3.The 3rd channel can be programmed to
give a pulsing output when alarm is trig-
gered to be connected to the car horn.
4. 2nd channel Auto disarm feature, when
