W
I R E D
L
A U N D R Y
M
A C H I N E
I
N T E R F A C E
I
N S T A L L A T I O N
Laundry Installation and Setup Guide
16
W
I R E D
L
A U N D R Y
M
A C H I N E
I
N T E R F A C E
I
N S T A L L A T I O N
W
I R E D
L
A U N D R Y
M
A C H I N E
I
N T E R F A C E
I
N S T A L L A T I O N
The wired solution supports up to 60 laundry machines. In laundry centers with 20 or fewer machines, a single LCM20 is
installed inside the LC3000 enclosure. If your Laundry Center supports more than 20 machines, you must purchase an
LCM20 and an LE3/PSENCL for each additional set of 20 machines. The LC3000 reader can support a maximum of three
(3) LCM20s. An LCI, which includes a wiring harness that communicates with the laundry machine controller, must be
installed in every laundry machine and is attached to a cable connected to the LCM20.
Two 5-pin lead sets exit from the power supply compartment.
In the LC3000, the longer lead set connects to the LC3000 controller board on the door of the enclosure; the shorter lead
set connects to the LCM20 board. Do not connect the lead set to the LCM20 board until all connections have been made
to machines.
LE3/PSENCL
AND
LCM20 I
NSTALLATION
LE3/PSENCL and LCM20 Placement
Consider the following criteria before you place the external LCM20 and LE3/PSENCL:
• 120VAC power availability
• Wiring distance limitation of 400’ from Laundry Reader (LC3000) or Multiplexer (LCM20) to the laundry machines
• Ease of cable routing to laundry machines
Install the LCM20 Board in the LC3000
1
With the enclosure door open, position the LCM20
board, with component side facing out (see
).
2
Secure the LCM20 board using the #4-40 screws
from the hardware kit.
Figure 7: LCM20 Board in the LC3000 Enclosure
ACMAIN
L N G
