L C I L
A U N D R Y
M
A C H I N E
I
N T E R F A C E
I
N S T A L L A T I O N
Laundry Installation and Setup Guide
19
L C I L
A U N D R Y
M
A C H I N E
I
N T E R F A C E
I
N S T A L L A T I O N
LCI L
AUNDRY
M
ACHINE
I
NTERFACE
I
NSTALLATION
Install an LCI in every laundry machine. An LCI consists of a wiring harness that interfaces with the laundry machine
controller and is attached to a cable connected to the LCM20. Several models of LCI are available. Use
Table 1: Laundry System Components, on page 8
to select the correct LCI model number based on the manufacturer
and model of your laundry machines.
Wiring harness (LCI) connects under machine controller and describes the blocks.
Install Maytag LCI3010 in Laundry Machine
The hardware kit includes machine controller interface cables, splices, and wire ties. Two cables are included to
support both single machines and stacked dryers. If you are installing a single machine, discard the two-wire cable.
1
Remove the operator console (with display and switches) from the machine (only the screws in the top two corners
need to be removed).
2
Route the 4-conductor cable from the LCM20 into the laundry machine for connection to the LCI wiring harness.
To prevent tampering, flexible metal conduit is recommended to run the 4-conductor cable from LCM20 to
the back of the machine. If flexible metal conduit is not used, then a strain relief must be used to prevent
damage to the cable.
3
Attach female bullet connectors from the hardware kit to the end of the 4-conductor cable.
Use a strain relief or other means to secure the cable where it enters the machine.
4
Insert the female bullet connectors into the LCI3010 wiring harness (white to white, black to black, etc.).
)
If the installation is for a stacked
machine, the additional two-wire
harness must be connected.
5
Install the LCI wiring harness by
inserting the six-pin Molex into the
connector of the laundry
machines circuit board.
6
Use the wire ties and wire tie
blocks included in the hardware
kit to dress the wires.
Figure 12: Single Maytag Machine
BELDEN 8723 or equivalent
Single Maytag
LCI 3010
Cable to LCM20
6
5
4
3
2
1
1
2
3
4
LCM20
TBX
RED
BLK
WHT
RED
WHT
BLK
Laundry Machine
RED
WHT
BLK
