L C I L
A U N D R Y
M
A C H I N E
I
N T E R F A C E
I
N S T A L L A T I O N
Laundry Installation and Setup Guide
22
L C I L
A U N D R Y
M
A C H I N E
I
N T E R F A C E
I
N S T A L L A T I O N
5
Attach the orange wire with the
female disconnect to the
spade lug on the controller
board identified with the letter
M1
.
Figure 15: Whirlpool/Advantech Machine
6
Attach the black wire with the female disconnect to the spade lug on the controller board identified with the letter
M2
.
7
Connect the 4-pin Molex connector from the wiring harness to the mating connector on the laundry machine
controller board identified as
COIN #1
.
8
Use the wire ties and wire tie blocks, included in the hardware kit, to dress the wires.
9
Terminate 4-conductor cable at the LCM20, using the 1 x 4 terminal block provided in the hardware kit; and install
the terminal block on the terminal header of the LCM20.
Refer to
Figure 11: External LCM20 Terminal Connections
(page 18). Be sure terminal block numbers match
laundry machine numeric identifiers.
10
Replace laundry machine operator console.
BELDEN 8723 or equivalent
Whirlpool
LCI 3030
Cable to LCM20
1
2
3
4
LCM20
RED
BLK
WHT
Whirlpool Circ uit Board
4-pin Molex Connector
M1
M2
TBX
RED
BLK
WHT
Install Female Bullet Splices
RED
BLK
WHT
ORG
BLK
