DRAFT
W
A L L
M
O U N T
I
N S T A L L A T I O N
P
RINTED
N
OVEMBER
3, 2009
1-8
Figure 1-13 Reader Secured to Pivot Plate - Attended Wall Mount
9
Position the pivot plate to the desired angle, and then tighten the 2 locking screws (1/8” pin hex driver).
Unattended Wall Mount Installation
1
Find a location on a single gang box to mount the MF4100.
Ensure there is enough clearance for the operator to access the touchscreen and swipe cards.
2
Remove the two base extensions by removing the 4 screws (1/8” pin hex driver).
3
Route the required cables through the VESA bracket cable hole, and then the pivot bracket hole.
Note the orientation of the VESA bracket to the wall.
Figure 1-14 VESA Bracket - Unattended Wall Mount
Note: The pivot plate attaches to the bottom of the MF4100 reader.
Route Cables
Pivot Plate
