DRAFT
W
A L L
M
O U N T
I
N S T A L L A T I O N
P
RINTED
N
OVEMBER
3, 2009
1-6
W
ALL
M
OUNT
I
NSTALLATION
The VESA mounting bracket allows for two wall mount installation options:
•
Attended Wall Mount Installation
•
Unattended Wall Mount Installation
Attended Wall Mount Installation
1
Find a location on a single gang box to mount the MF4100.
Ensure there is enough clearance for the operator to access the touchscreen and swipe cards.
2
Remove the two base extensions by removing the 4 screws (1/8” Pin hex driver).
3
Place the two locking screws in the position that allows the tilt plate to pivot (1/8” Pin hex driver).
VESA Bracket Screw Position - Attended
4
Route the required cables through the VESA bracket cable hole, and then the pivot bracket hole.
Note the orientation of the VESA bracket to the wall.
Figure 1-10 VESA Bracket - Attended Wall Mount
Note: The pivot plate attaches to the bottom of the MF4100 reader.
5
Attach the mounting base to the gang box using the two #6-32 pin hex screws provided in the
hardware kit.
6
Install cables to the connectors of the MF4100.
Route Cables
Pivot Plate
