DRAFT
M
U L T I
- F
U N C T I O N
R
E A D E R
M F 4 1 0 0 I
N S T A L L A T I O N
G
U I D E
D
O C U M E N T
1 2 9 5 R
E V
0 1
P
RINTED
N
OVEMBER
3, 2009
1-7
The MF4100 can be powered using the +12 Volt wall mount power supply (included), or Power
Over Ethernet (POE) switch. The power supply requires a dedicated 110 VAC outlet. POE
provides power through the network cable, and reduces cable clutter. A CAT-5 cable must be
connected between the POE switch to the RJ-45 connector on the MF4100 labeled Network,
see the diagram below. When providing power with POE, the maximum LAN cable length
must not exceed 100 meters.
Figure 1-11 MF4100 Cable Ports
7
Place the security plate onto the MF4100, and then route the cables through the plate opening.
Note the orientation of the VESA bracket to the security plate.
Figure 1-12 Attended Wall Mount VESA Bracket Orientation
8
Place the MF4100 assembly on the pivot plate, and then secure using four M4 x 6mm machine screws
provided in the hardware kit.
Power Supply
Network/POE
Copy
Print/LWCFG
AUX1/Bridge
AUX2/LCM
Config
USB
Expansion
Security plate
