DRAFT
M
U L T I
- F
U N C T I O N
R
E A D E R
M F 4 1 0 0 I
N S T A L L A T I O N
G
U I D E
D
O C U M E N T
1 2 9 5 R
E V
0 1
P
RINTED
N
OVEMBER
3, 2009
1-9
4
Attach the mounting base to the gang box using the two #6-32 pin hex screws provided in the
hardware kit.
5
Install cables to the connectors of the MF4100.
6
Place the security plate onto the MF4100, and then route the cables through the plate opening.
Note the orientation of the VESA bracket to the security plate.
Figure 1-15 Unattended Wall Mount VESA Bracket Orientation
7
Place the MF4100 assembly on the pivot plate, and then secure using four M4 x 6mm machine screws
provided in the hardware kit.
8
Position the pivot plate to the desired angle, and then tighten the 2 locking screws (1/8” pin hex driver).
Security plate
