2
GO!® Quick Start:
Perform the following steps to assemble your handheld radio:
Charge the battery.
Install the battery.
Install the antenna.
Install the belt clip.
Turn on the radio.
Select a channel.
Install your audio accessory (if needed).
Adjust the volume.
Charging the Battery
The radio is powered by a Li-Ion battery. To protect the battery from damage and comply with the warranty
conditions, you can use only the charger provided with the battery for charging. To maximize battery performance,
it is recommended to charge the battery for 10 to 12 hours before the first use.
Installing the Battery
Align the battery with the battery slot on the rear side of the radio. Push the battery into the slot until it is fastened.
Before removing the battery, turn off the radio first. Press the battery fastener, and then remove the battery.
Installing the Antenna
Turn off the radio, place the antenna into the installation hole, and turn the antenna clockwise. To remove the
antenna, turn the antenna anticlockwise. Before removing the antenna, ensure that you have turned off the radio
and removed the universal interface cover. To replace the antenna, use a specified antenna to replace the old one.
Otherwise, your radio may be damaged.
Installing the Belt Clip
Align the screw holes on the belt clip with those on the rear side of the radio, and fasten the belt clip with screws
Turning On the radio
Turn the volume/power knob clockwise until you hear a click sound. The radio gives a short beep sound,
indicating that the radio is successfully turned on.
Selecting a Channel
Simply look at the knob with the numbers and rotate until you land onto the group channel you desire. You
should also hear the Voice Enunciation through the speaker or earpiece of which channel you are on.
