STAT-4, STAT-8, AND STAT-24
12
3.5 Installing the Mux in 19" Racks
Install the stat muxes in 19" racks. Rack height is 1U (1.75"). The width of the Stat-8 is slightly less than half of
the available mounting width, and Stat-24 width is equal to the available width. Two rack adapter kits are
available for the Stat-8; one kit provides the hardware you need to install a single mux, and the other provides
the hardware you need to install two muxes, side-by-side. Another rack adapter kit is available for the Stat-24.
Call Technical Support for details.
WARNING
Disconnect the units from AC power while performing the following procedures.
3.5.1 I
NSTALLING A
S
INGLE
S
TAT
-8
The rack adapter kit for single-mux installation includes one short bracket and one long bracket. Fasten the
brackets via screws to the two side walls of the case, as shown in Figure 3-3.
To prepare the mux for rack installation, attach the two brackets to the side walls of the mux. Each bracket
fastens via two screws (with flatwashers), which you insert into the two front holes on the side wall (nuts are
already in place, on the inner side of the wall). After attaching the brackets, the mux is ready to install in the
19" rack. Fasten the brackets to the side rails of the 19" rack via four screws (not included in the kit), two on
each side.
Figure 3-3. Installing a single Stat-8 in a 19" rack.
