10
engLiSh / itaLiano / françiaS / eSpañoL
InstallatIon • InstallazIone • InstallatIon • InstalacIón
eng:
The Blackburn Atom uses a single wired sensor attached to the front fork.
inStAlling wired Speed SenSor And BrAcket
1. Loosely attach the wheel sensor to either fork blade using the zip-ties. Do not fully tighten.
2. Attach the spoke magnet on same side of wheel as sensor.
3. Adjust the positions of sensor and magnet so the magnet passes 1-3 mm from the sensor.
4. Route the remaining wire and bracket up the fork securing it with tape. Wrap the excess
wire around the front brake cable housing allowing enough slack for the bracket to reach the
handlebars. Attach the bracket to the handlebars or stem. Tighten magnet and zip-ties.
1
4
2
3
BlackBurn_AtomSL_Eng-IT-FR-SP.indd 10
12/7/10 4:50:45 PM