c)
When ba
�
ery pack is not in use, keep it away from other metal objects, like
paper clips, coins, keys, nails, screws or other small metal objects, that can make a
connec
�
on from one terminal to another.
Shor
�
ng the ba
�
ery terminals together may
cause burns or a
fi
re.
d)
Under abusive condi
�
ons, liquid may be ejected from the ba
�
ery; avoid contact.
If contact accidentally occurs,
fl
ush with water. If liquid contacts eyes, addi
�
onally
seek medical help.
Liquid ejected from the ba
�
ery may cause irrita
�
on or burns.
e)
Do not use a ba
�
ery pack or tool that is damaged or modi
fi
ed.
Damaged or
modi
fied
ba
�
eries may exhibit unpredictable behaviour resul
�
ng in
fi
re, explosion or risk of
injury.
f)
Do not expose a ba
�
ery pack or tool to
fir
e or excessive temperature.
Exposure to
fi
re or temperature above 130
°
C may cause explosion.
NOTE The temperature
„
130
°
C”can be replaced by the temperature
„
265
°
F”.
g)
Follow all charging instruc
�
ons and do not charge the ba
�
ery pack or tool
outside the temperature range speci
fi
ed in the instruc
�
ons.
Charging improperly or at
temperatures outside the speci
fied
range may damage the ba
�
ery and increase the risk of
fi
re.
6.Service
a)
Have your power tool serviced by a quali
fi
ed repair person using only iden
�
cal
replacement parts.
This will ensure that the safety of the power tool is maintained.
b)
Never service damaged ba
�
ery packs.
Service of ba
�
ery packs should only be
performed by the manufacturer or authorized service providers.
Drill Safety Warnings
1)
Safety instruc
�
ons for all opera
�
ons
a)
Wear ear protectors when impact drilling.
Exposure to noise can cause hearing loss.
b)
Hold the power tool by insulated gripping surfaces, when performing an
opera
�
on where the cu
�
ng accessory or fasteners may contact hidden wiring or its
own cord.
Cu
�
ng accessory contac
�
ng a “live” wire may make exposed metal parts of the
power tools “live” and could give the operator an electric shock.
2)
Safety instruc
�
ons when using long drill bits
a)
Never operate at higher speed than the maximum speed ra
�
ng of the drill bit.
At
higher speeds, the bit is likely to bend if allowed to rotate freely without contac
�
ng the
workpiece, resul
�
ng in personal injury.
b)
Always start drilling at low speed and with the bit
�
p in contact with the
workpiece.
At higher speeds, the bit is likely to bend if allowed to rotate freely without
contac
�
ng the workpiece, resul
�
ng in personal injury.
c)
Apply pressure only in direct line with the bit and do not apply excessive
pressure.
Bits can bend causing breakage or loss of control, resul
�
ng in personal injury.
For ba
�
ery tools:
1) Instruc
�
ons regarding
ba
�
ery
charging, informa
�
on regarding ambient temperature range for
tool and
ba
�
ery
use and storage, and the recommended ambient temperature range for the
