________________________________________PL10C / PL20B_____________________________________
7
RISKS DUE TO STRAIGHTENING
DANGER
The straightening systems have been designed for the use of important forces. Improper installation or
preparation, unsafe anchoring of the vehicle and its accessories or the use of defect, damaged or overloaded
chains or other equipment can cause damages or personal injury, even death.
CAUTION
You must wear individual protective equipment (safety shoes
, gloves
) during both the installation
and use of the equipment.
-
Do not use any other chains than those supplied with this equipment.
Display in your workshop, explain and respect the safety and stocking
instructions supplied with the pulling chains.
-
Always use the safety cable for pulling with the chains.
-
Do not wind chains, cables or straps around the sharp parts of the vehicle, or they could be damaged.
-
Do not stand in front of or behind the pulling devices while in use.
-
Always make sure that the anchoring and pulling accessories and clamps are correctly set up.
-
Keep the jaws of the clamps clean to avoid sliding. Replace used or damaged jaws.
-
Always set up the Dozer and lock it to the frame before lifting or performing a pull. Set up the rotation-
locking axis of the arms before pulling.
-
Always set up and lock the Dozer to the frame before rotating the Dozer arms to adjust the pulling angle.
Put the arms of the Dozer back in vertical position and lock your Dozer by the means of the axis before
you remove it from the frame.
-
Do not exceed the maximum allowed capacity of the (PMP8111).pump: 700 bars
-
Do not use the hydro-electric pump in places where there is a risk of combustible vapours.
CAUTION
Never let any incompetent or insufficiently trained person use this equipment.
DECALS:
It is your responsibility to keep all warning and safety decals clean and legible at all times. Please contact
BLACKHAWK for free replacement decals.
