Hardware Installation
38
Universal Videohub 150W Power Supply
The Universal Videohub 150W Power Supply is a "brick" style power supply which connects to a Universal
Videohub 450W Power Card. You will need to connect 3 power supplies for each Universal Videohub 450W
Power Card you install in a Universal Videohub 288. You will need to provide a standard IEC cord with a C13
connector for each power supply.
Adding a Universal Videohub 150W Power Supply
It is important to ensure that no power is connected until the power supplies are fully installed and ready to
be powered on. Accordingly please carry out the installation procedure in the following order:
Step 1.
Ensure that any new brick power supplies are disconnected from any electrical source.
Step 2.
Connect each new power supply to the Universal Videohub 450W Power Card.
Step 3.
Tighten the thumb screws on all power connectors.
Step 4.
Connect an IEC cord from each new power supply to the wall socket and turn on the power.
If you need to remove or replace a power brick while Universal Videohub 288 is still running from a second
power card and set of power supplies, power off the brick while being careful to avoid switching off power
to the remaining power supplies. Unplug the IEC cord and then unscrew and disconnect the power supply
from the Universal Videohub 450W Power Card.