The PL mount kit includes:
1x PL mount
The PL mount is shipped with a protective
dust cap.
1 x Shim set
The shim set includes the following thicknesses:
0.50mm
0.30mm
0.20mm
0.18mm
0.15mm
0.12mm
0.10mm
0.05mm
0.025mm
1x PL baffle
The PL mount baffle helps to control and direct the
light entering the sensor.
1x Baffle tool
Use the PL baffle tool to tighten the baffle in
your camera.
5 x 2mm Hex M2.5 x 22mm mount screws
The five M2.5 x 22mm Hex screws are exclusive to
the PL mount so you can keep the screws together
with the respective mount.
Tools Required
When attaching the PL mount, you will need a 2mm Hex driver. While it’s not absolutely
required, we recommend using a torque wrench able to accurately set a maximum torque
of 0.45Nm to reduce the potential of over tightening the screws.
2mm Hex driver
172
Interchangeable Lens Mount
