Mounting Blackmagic Camera Fiber Converter
Blackmagic Camera Fiber Converter mounts to the back of URSA Mini and URSA Broadcast
directly behind the camera body, and connects to your camera’s rear SDI in and SDI out BNC
connectors. If you have installed a battery plate to the rear of your camera, you will need to
remove it before connecting the Blackmagic Camera Fiber Converter.
When attaching Blackmagic Camera Fiber Converter, you will need the following tools:
1 x phillips head screwdriver
1 x T10 torx screwdriver
To attach the Blackmagic Camera Fiber Converter to your URSA Mini or URSA Broadcast,
you will need a large phillips head screwdriver and a T10 torx driver
To mount and connect Blackmagic Camera Fiber Converter:
1
2
SDI
OUT
SDI
IN
REF
IN
TC I
N
12V
Ensure your camera is powered off. If using
URSA Broadcast or URSA Mini Pro, power it off
by moving the power switch to ‘off’.
Remove the battery plate or molex power cover
plate, if attached, using a phillips head
screwdriver.
NOTE
Before installing Blackmagic Camera Fiber Converter you should check that
URSA Mini’s internal software is version 4.4 or above and URSA Broadcast is 4.6 or
above. You can check your software version on page 4 of the camera's 'setup' menu.
For more information on updating your camera firmware see the section ‘Blackmagic
Camera Setup Utility' in this manual.
145
Getting Started with Blackmagic Fiber Converters