107-B00 Page 11/16
MAINTENANCE
22. Attach a new bearing cover gasket (26) and inboard
bearing cover (27A) to the inboard head. Install the
outboard bearing cover (27) and a new gasket to the
outboard head. Make sure the grease fittings (76) on
the bearing covers are accessible. Install and torque
bearing cover capscrews (28) to 30 lbs ft (40.7 Nm).
23. On 2" models, slide the dirt shield (123A) over the shaft
and push it firmly against the inboard bearing cover.
24. RELIEF VALVE ASSEMBLY
a. Insert the valve (9) into the relief valve bore of the
casing with the fluted end inward.
b. Install the relief valve spring (8) and spring guide (7)
against the valve.
c. Attach a new relief valve O-ring (10) and the valve
cover (4) on the cylinder.
d. Screw the relief valve adjusting screw (2) with locknut
(3) into the valve cover (4) until it makes contact with
the spring guide (7).
e. After the relief valve has been adjusted, tighten the
Locknut (3) and install the relief valve cap (1) and O-
ring (88)
NOTICE:
The relief valve setting MUST be tested and adjusted
more precisely before putting the pump into service.
Refer to "Relief Valve Setting and Adjustment"
Operation without guards in place can
cause serious personal injury, major
property damage, or death.
Do not operate
without guard in
place.
25. Reinstall coupling, shaft key, and coupling guards.
26. Refer to “Pre-Start Up Check List” and “Start Up
Procedures” sections of this manual prior to restarting
pump operation.
