Blade Blade 350 QX2 AP Combo, Instruction Manual

5

EN

The Battery Charging Process

1. Connect the AC power supply to the charger.

2. Connect the AC power supply to an AC power source. 

The green LED blinks.

3. Connect the battery to the charger. The red LED 

blinks, indicating charging. When the battery nears 
full charge, the red and green LEDs blink, indicating 
cell balancing.

4. Disconnect the battery when the green LED glows 

solid.

Charging the Flight Battery

Charger Specifi cations

• Input Voltage: 10.5–15V DC
• Charge Current: 3.5A

LED Indications

Green Blinking:

 Ready to Charge

Red Blinking:

 Charging

Red & Green Blinking:

 Cell Balancing

Green Solid:

 Charging Complete

Red Solid:

 Error

CAUTION:

 Overcharging a battery can cause 

a fi re.

NOTICE:

 If using a battery other than the included 

Li-Po battery, refer to your battery manufacturer’s 
instructions for charging.

1a

1b

2

3

Install the Gimbal

Install the Camera

1.  Follow the instructions included with your camera to 

charge the camera battery and install the micro SD 
card (

not included

).

2.  Slide the camera fully into the gimbal as shown.
3.  Insert the Wi-Fi antenna through the mount and into the 

camera body until it clicks. Rotate the antenna 90° in 
either direction to lock the antenna and camera to the 
mount.

4.  Install the 3mm mounting screw to secure the CGO1 to 

the mount.

Refer to the included camera and gimbal manuals for 
operating instructions.

1

2

3

4

1.  Slide the gimbal onto the mount as shown until it locks.
2.  Connect the cable from the aircraft to the port on the 

gimbal as shown.