11
EN
Problem
Possible Cause
Solution
LED on receiver fl ashes rapidly
and aircraft will not respond to
transmitter (during binding).
Transmitter too near aircraft during bind-
ing process.
Power off the transmitter. Move the transmitter
a larger distance from the aircraft. Disconnect
and reconnect the fl ight battery to the aircraft.
Follow the binding instructions.
Bind switch or button was not held while
transmitter was powered on.
Power off transmitter and repeat bind process.
Aircraft or transmitter is too close to large
metal object, wireless source or another
transmitter.
Move aircraft and transmitter to another
location and attempt binding again.
LED on the receiver fl ashes rap-
idly and the quadcopter will not
respond to the transmitter (after
binding).
Less than a 5-second wait between fi rst
powering on the transmitter and connect-
ing the fl ight battery to the quadcopter.
Leave the transmitter powered on. Disconnect
and reconnect the fl ight battery to the
quadcopter.
The quadcopter is bound to a different
model memory (ModelMatch™ transmit-
ters only).
Select the correct model memory on the
transmitter. Disconnect and reconnect the fl ight
battery to the quadcopter.
Flight battery or transmitter battery charge
is too low.
Replace or recharge batteries.
Aircraft or transmitter is too close to
large metal object, wireless source or
another transmitter.
Move aircraft and transmitter to another
location and attempt connecting again.
Crashes immediately upon lift-off
Propellers in wrong locations or
incorrect fl ight mode selected.
Ensure propeller direction and motor
direction are correct.
