17
EN
Post-Flight Inspection and Maintenance Checklist
√
Cleaning
Make sure the battery is not connected before cleaning. Remove dust and debris with a soft brush or a dry, lint-free
cloth.
Motors
Replace the motor when the model will not fly steady or veers off when doing a climb out.
Wiring
Make sure the wiring does not block moving parts. Replace damaged wiring and loose connectors.
Fasteners
Make sure there are no loose screws, other fasteners or connectors. Do not over-tighten metal screws in plastic
parts. Tighten screws so the parts are mated together, then turn screw only 1/8th of a turn more.
Propellers
Make sure there is no damage to the propellers or other parts that move at high speed. Damage to these parts
includes cracks, burrs, chips or scratches. Replace damaged parts before flying.
Troubleshooting Guide
Problem
Possible Cause
Solution
Control response is
inconsistent or requires extra
trim to neutralize movement
Aircraft not initialized on a level surface Disconnect the flight battery, center the con-
trol trim and re-initialize the quadcopter
Battery not correctly placed in
battery slot
Adjust battery position so quadcopter bal-
ances in the center of the frame
Will not respond to throttle
Throttle too high and/or throttle trim is
too high
Reset controls with the throttle stick
and throttle trim at the lowest setting
Quadcopter moved during initialization
Disconnect the flight battery and
re-initialize the quadcopter while
keeping it from moving
Throttle channel is reversed
Disconnect flight battery, reverse the throttle
channel on the transmitter,
recconnect flight battery
Does not function and smells
burnt after connecting the flight
battery
Flight battery connected with the wrong
polarity
Replace the 4-in-1 board. Connect the flight
battery noting proper polarity
Summary of Contents for Glimpse BNF BLH2280
Page 1: ...RTF READY TO FLY ...
