18
EN
Problem
Possible Cause
Solution
Reduced flight time
or is underpowered
Flight battery charge is low
Completely recharge the flight battery
Inadequate power to flight battery
charger
Use a different USB power source for the
charger
Flight battery is damaged
Replace the flight battery and follow the
flight battery instructions
Flight conditions might be too cold
Make sure the battery is warm (room tem-
perature) before use
LED on receiver flashes rapidly
and quadcopter will not respond
to transmitter (during binding)
Transmitter too near aircraft during
binding process
Power off the transmitter. Move the transmit-
ter a larger distance from the aircraft. Dis-
connect and reconnect the flight battery to
the aircraft. Follow the binding instructions
Bind switch or button was not held
while transmitter was powered on
Power off transmitter and repeat bind
process
Aircraft or transmitter is too close to
large metal object, wireless source or
another transmitter
Move aircraft and transmitter to another
location and attempt binding again
LED on the receiver flashes
rapidly and the quadcopter will
not respond to the transmitter
(after binding)
Less than a 5-second wait between
first powering on the transmitter and
connecting the flight battery to the
quadcopter
Leave the transmitter powered on. Discon-
nect and reconnect the flight battery to the
quadcopter
The quadcopter is bound to a different
model memory (ModelMatch™ trans-
mitters only)
Select the correct model memory on the
transmitter. Disconnect and reconnect the
flight battery to the quadcopter
Flight battery or transmitter battery
charge is too low
Replace or recharge batteries
Aircraft or transmitter is too close to
large metal object, wireless source or
another transmitter
Move aircraft and transmitter to another
location and attempt connecting again
Crashes immediately upon
lift-off
Propellers in wrong locations or
incorrect flight mode selected
Make necessary adjustments
Summary of Contents for Glimpse BNF BLH2280
Page 1: ...RTF READY TO FLY ...
