23
EN
This device complies with part 15 of the FCC rules. Operation
is subject to the following two conditions:
1.
This device may not cause harmful interference.
2.
This device must accept any interference received,
including interference that may cause undesired operation.
CAUTION:
Changes or modifications not expressly
approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
This product contains a radio transmitter with wireless
technology which has been tested and found to be compliant
with the applicable regulations governing a radio transmitter
in the 2.400GHz to 2.4835GHz frequency range.
Antenna Separation Distance
When operating your Spektrum transmitter, please be sure
to maintain a separation distance of at least 20 cm between
your body (excluding fingers, hands, wrists, ankles and feet)
and the antenna to meet RF exposure safety requirements as
determined by FCC regulations.
The illustrations show the approximate 20 cm RF exposure
area and typical hand placement when operating your
Spektrum transmitter.
This device complies with Industry Canada license-exempt
RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, Including interfer-
ence that may cause undesired operation of the device.
FCC Information
IC Information
This equipment has been tested and found to comply with the
limits for Part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in
a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment to an outlet on a circuit different
from that to which the receiver is connected.
Summary of Contents for Glimpse BNF BLH2280
Page 1: ...RTF READY TO FLY ...
