Blade mSR X, User Manual

6

EN

Transmitter and Receiver Binding

Binding is the process of programming the receiver of the control unit to recognize the GUID (Globally Unique  

Identifier) code of a single specific transmitter. You need to ‘bind’ your chosen Spektrum

™

 or JR

®

 DSM

®

technology equipped aircraft transmitter to the receiver for proper operation. If you purchased an RTF model, 

the transmitter is bound to the model at the factory.
To bind or re-bind your heli to your chosen transmitter, please follow the directions below:

MLP4DSM Binding Procedure

1. Disconnect the flight battery from the helicopter.
2. Center all trims on your transmitter (refer to transmitter control section below for trim instructions).
3. Power off the transmitter and move the throttle stick to the down/off position.
4. Connect the flight battery in the helicopter. The LED on the 4-in-1 Control unit flashes after 5 seconds.
5.  Push in hard and hold down the left stick while powering on the transmitter (you will hear a mechanical 

‘click’ when pushing in the stick).

6.  Release the left stick. The transmitter will beep and the power LED will blink.
7.  The helicopter is bound when the blue LED on the 4-in-1 unit is solid.
8. Disconnect the flight battery and power the transmitter off.

General Binding Procedure

1. Disconnect the flight battery from the helicopter.
2. Select a clean model memory on your transmitter (computer radios only). 
3. Select Acro or Airplane model type on your transmitter.
4. Make sure all servo reversing is set to Normal on your transmitter.
5. Center all trims and make sure sub-trims are disabled (zeroed) on your transmitter.
6. Power off the transmitter and move all switches to the 0 position. Move the throttle to the low/off position.
7. Connect the flight battery in the helicopter. The LED on the 4-in-1 control unit flashes after 5 seconds.
8. Put the transmitter into bind mode while powering on the transmitter.
9. Release the bind button or switch on your transmitter after 2–3 seconds.  The helicopter is bound when 

the blue LED on the 4-in-1 control unit is solid.

10. Disconnect the flight battery and power the transmitter off.

If you encounter problems, obey binding instructions and refer to the troubleshooting guide for other  

instructions.  If needed, contact the appropriate Horizon Product Support office. For a list of compatible DSM 

transmitters, please visit www.bindnfly.com.

NOTICE:

 Futaba transmitters (equipped with Spektrum modules) may require you to reverse the throttle channel.