9
EN
Transmitter and Receiver Binding
Binding is the process of programming the receiver to recognize the GUID (Globally Unique Identifi er) code of a
specifi c transmitter. You need to ‘bind’ your chosen
Spektrum
™
or
DSM2
®
/DSMX
®
technology equipped aircraft
transmitter to the receiver for proper operation. If you purchased an RTF model, the transmitter is bound to the
model at the factory.
To bind or re-bind your nano QX to your chosen transmitter, please follow the directions below.
General Binding Procedure
1. Disconnect the fl ight battery from the quadcopter.
2. Select a clean model memory on your transmitter (computer radios only).
3. Select Acro or Airplane model type on your transmitter.
4. Make sure all servo reversing is set to Normal on your transmitter.
5. Center all trims on your transmitter.
6. Power off the transmitter and move all switches to the 0 position. Move the throttle to the low/off position.
7. Connect the fl ight battery in the quadcopter. The blue LED on the 4-in-1 control unit fl ashes after 5
seconds.
8. Put the transmitter into bind mode while powering on the transmitter.
9. Release the bind button/switch after 2–3 seconds. The quadcopter is bound when the blue LED on the
4-in-1 control unit turns solid.
10. Disconnect the fl ight battery and power the transmitter off.
CAUTION:
When using a Futaba
®
transmitter with a
Spektrum
DSM2/DSMX
module, you must reverse the
throttle channel and rebind. Refer to your
Spektrum
module manual for binding and failsafe instructions.
Refer to your Futaba transmitter manual for instructions on reversing the throttle channel.
