Blade Nano QX2 FPV, Instruction Manual

6

EN

CAUTION:

 All instructions and warnings must be 

followed exactly. Mishandling of Li-Po batteries can 

result in a fi re, personal injury and/or property damage.

•  NEVER LEAVE CHARGING BATTERIES UNATTENDED.
•  NEVER CHARGE BATTERIES OVERNIGHT.

•  By handling, charging or using the included Li-Po battery, 

you assume all risks associated with lithium batteries.

•  If at any time the battery begins to balloon or swell, 

discontinue use immediately. If charging or discharging, 
discontinue and disconnect. Continuing to use, charge 
or discharge a battery that is ballooning or swelling can 
result in fi re.

•  Always store the battery at room temperature in a dry 

area for best results.

•  Always transport or temporarily store the battery in a 

temperature range of 40–120º F (5–49° C).

•  Do not store battery or model in a car or direct sunlight. 

If stored in a hot car, the battery can be damaged or 
even catch fi re.

•  Always charge batteries away from fl ammable materials.
•  Always inspect the battery before charging.
•  Always disconnect the battery after charging, and let the 

charger cool between charges.

•  Always constantly monitor the temperature of the battery 

pack while charging.

•  ONLY USE A CHARGER SPECIFICALLY DESIGNED TO 

CHARGE LI-PO BATTERIES. Failure to charge the battery 
with a compatible charger may cause a fi re resulting in 
personal injury and/or property damage.

•  Never discharge Li-Po cells to below 3V under load.
•  Never cover warning labels with hook and loop strips.
•  Never charge batteries outside recommended levels.
•  Never charge damaged batteries.
•  Never attempt to dismantle or alter the charger.
•  Never allow minors to charge battery packs.
•  Never charge batteries in extremely hot or cold places 

(recommended between 40–120° F or (5–49° C) or place 
in direct sunlight.

Charging Warnings

First Flight Preparation

•  Remove and inspect contents
•  Begin charging the fl ight battery
•   Install the fl ight battery in the quadcopter 

(once it has been fully charged)

•  Program your computer transmitter
•  Bind your transmitter
•  Familiarize yourself with the controls
•  Find a suitable area for fl ying

Flying Checklist

❏

Always turn the transmitter on fi rst

❏

 Plug the fl ight battery into the lead from the 4-in-1 
control unit

❏

 Allow the 4-in-1 control unit to initialize and arm properly

❏

Fly the model

❏

Land the model

❏

 Unplug the fl ight battery from the 4-in-1 control unit

❏

Always turn the transmitter off last