6
EN
Binding
Transmitter Controls
A
B
C
D
E
F
Aileron (Roll)
(Left/Right)
Elevator
(Pitch)
(Up/Down)
Elevator Trim Aileron Trim Rudder Trim Throttle Trim
Rudder
(Yaw)
(Left/Right)
Throttle
(Up/Down)
Dual Rate Switch
A
B
C
D
E
F
On/Off Switch
LEDs
Flight Mode Switch
Bind Button
LED
Monitor Cradle
Binding Procedure
1. Power off your transmitter.
2. Remove the upper rear cover of the aircraft. Press down on
the rear edge of the cover and pull the cover out of the frame.
3. Power on the aircraft.
4. Press and hold the bind button until the red LED on the
control board fl ashes rapidly.
5. Power on the transmitter. The LED on the control board
glows solid to show the bind was successful.
The transmitter included with this aircraft is pre-bound to the
receiver at the factory. If it becomes necessary to re-bind the
transmitter to the receiver, indicated by a red receiver status
LED, follow the procedure given in the table.
If you encounter problems, obey the binding instructions and refer
to the troubleshooting guide for further instructions. If necessary,
contact the appropriate Horizon Hobby product support offi ce.
Failsafe/Beacon
The quadcopter will autoland and start beeping if the signal
from the transmitter is lost. This feature can be used as a
beacon to help locate the quadcopter, if it has crashed, by
turning off the transmitter and listening for the beeping of
the aircraft.
