21
1. Care has been taken to assure that your bike has been properly adjusted and
lubricated at the factory. It is not recommended that the user attempt service on
the internal components; instead seek service from an authorized service center.
2. From time-to-time the outer surfaces may appear dull or dirty. Following the
instructions listed below will restore and preserve the original finish.
3. Clean the handlebars and seat after each workout with a disinfectant spray, and
remove any sweat from the bike frame.
4. Apply anti-rust to the flywheel every time you clean the machine or at least once
a month. Apply a very light coat of oil in the contact surface of the flywheel with
brake to avoid rattling noises.
5. Cleaning metal surfaces may be accomplished by using a soft cotton or terry cloth
rag with a light application of car wax. Do not use aerosol sprays or pump bottles
as they may deposit wax on the console surface.
6. From time-to-time the computer surface may collect dust or finger prints. The use
of harsh chemicals will destroy the protective coating and cause a static build up that
will damage the components. This surface may be cleaned with cleaning products
found in most computer supply stores, specially made for antistatic surfaces. It is
strongly recommended that you purchase such a cleaning compound.
7. The safely level of the equipment can only be maintained if it is regularly examined
for damage and/or wear and tear.
8. Care must be taken when lifting or moving the equipment so as not to cause injury.
9. The brake pad is most susceptible to wear. Before exercising inspect the braking
system for proper functionality.
10. Please check if all warning labels are in good condition and legible. If they are worn
or damaged please contact the distributor to order new sticker.
MAINTENANCE & CLEANING
CLEANING
: Wipe sweat off the cycle immediately after each workout and then with
a damp cloth. Clean dust from the cycle using a damp cloth or towel. Do not use
solvents. Use a vacuum cleaner to clean around the cycle. The cycle may be cleaned
underneath by laying it on its side. From time to time, check that all fasteners are
properly secured and tightened. Check and tighten up all the parts on your unit every
three months. Use of this machine with worn or weakened parts may cause the user
injury. If you have any doubts about the condition of any part, we recommend that
you replace it, using manufacturer’s spare parts. Use of non original spare parts may
cause injury or affect the performance of the machine.
