INSTALLATION
7
Switch Box Mounting
See power status indicator lights diagram page 2 for status of the Switch box fuses. If one of the
fuses fails the power indicator will not light on the switch that has failed. Please note that if the power
supply to the switch box has been switched off or interrupted due to the RCD circuit breaker or fuse
from the mains supply isolating the box none of the indicator lights will illuminate. Before replacing
the fuse please check the manufacturer’s manual of the appliance that has caused the fuse to blow.
The product may be faulty and in need of replacement or servicing by the manufacturer.
(1 x 5 AMP and 1 x 1.5 AMP spare fuses are located for your convenience on the circuit
board.)
3.
Remove the Switch box from its mounting bracket by lifting in a vertical action.
2.
Remove the four cover locating screws from the back of the box.
3. Having identified which switch fuse has blown (5 amp for switch 1 or 1.5 amp for subsequent
switches), remove the blue fuse cover and gently remove the fuse with an electrical screwdriver.
4.
Gently push the new fuse into place and replace the fuse cover (see page 2 for replacement
fuse codes)
5.
Replace the box cover ensuring that the cover seal is in place with the four screws at the back of
the box.
6.
Slide the Switch box vertically down onto the locating bracket.
Maintenance
It is recommended that once a season the cover seal and rubber buttons are checked for wear and
damage to ensure that a safe weatherproof seal is maintained.
If signs of wear are shown, remove and replace the parts (spares codes and descriptions page 2).
These should be readily available from your retailer.
IMPORTANT:
Always switch off the mains power and isolate the Switch box before removing
the cover.
