13
Amp
The right Amplifier section provides a voltage controlled amplifier. It is typically
used after the filters in the signal path as the output stage of the synth. Note,
the effects are connected just prior to the Amp section output in the signal
path.
• Level - Output level of the synth, pre-effects
• Mode - You can set the amp to operate on a linear scale or a dB scale.
Typically, you would use a linear scale.
• Drive - The drive algorithm provides saturation, soft clipping, or analog
modeled hard clipping from the CP-3 mixer. Note: The mode is selected on
the back.
• Modulation/Signal Inputs
Control 1
Amplifier level (typically an envelope)
Control 2
Amplifier level
Pan
Left/right panning
Signal
Input signal to the amp (typically the filters output)
© 2017 Blamsoft, Inc. All rights reserved.
Summary of Contents for VK-2
Page 1: ...1 0 0 User Manual Rev B...