Malfunctions
Malfunctions
Possible causes
Error correction
Blue LED on the mixer tap
is not lighting up
-
Mixer tap is not receiving
electricity
-
Connect the power supply unit for the control
box to the mains
-
Check the connections on the control box
-
The volume wheel is at “0”
-
Turn the volume wheel and set
an amount > “0”
Water does not run when
the sensor is activated
-
Connecting hoses
are kinked
-
Connecting hoses
are wrongly attached
-
The volume wheel is at “0”
-
Filter head is connected
against the flow direction
-
Electronic devices are
in front of the sensor
-
Connect hoses without kinks
-
Connect the hoses according to
the assembly instructions
-
Turn the volume wheel and set
an amount > “0”
-
Check whether the filter head has been
connected against the flow direction, and
change the flow direction
-
Remove electronic devices
Cold and/or warm water
is not running
-
Connecting hoses
are kinked
-
Connecting hoses are
wrongly attached
-
Connect hoses without kinks
-
Connect the hoses according to
the assembly instructions
The set water quantity
for filter or hot water is
significantly different
-
Malfunctions in the control
box
-
Unplug the power supply to the control box,
wait for 1 minute, then plug it in again
Do not use abrasive or chlorinated cleaning
products to clean the surfaces.
We recommend using BLANCO DailyClean
(item no. 526305) to clean the mixer tap. This is
easy to order from the BLANCO online shop.
Cleaning
38
39
Summary of Contents for drink.filter EVOL-S Pro
Page 92: ...182 183 ...
