3.4 OVEN LIGHT USE
With the light turned on you can watch the cooking through the oven glass window without
opening the door for your convenience and economy.
To switch on the oven light turn the knob which is under the symbol and place the symbol in the
upper position of the knob.
In some electric ovens the light turns on as soon as you turn the knob and stays alight until you
turn off the oven
.
3.5 ELECTRONIC PROGRAMMER
(FE6064X)
MANUAL MODE (MAN):
Manual mode if no cooking time or end of cooking time is selected.
The symbol “Man” is displayed. The time of day is shown on the 7-segment display unless the
minute minder is active.
AUTOMATIC MODE (AUTO):
If a cooking time or an end of cooking time is selected. The switch goes to automatic mode.
The symbol “Auto” is displayed until the cooking time or the end of cooking time has expired.
TIME OF DAY
Setting the current time
When the electricity has been connected, “12:00” and the symbol flash on the display. By
touching any of the controls (
+
,
-
or
SELECT
), the symbol “MAN”
appears, and it is possible to
adjust the time within 5 seconds by pressing
–
or
+
.
The time can be adjusted subsequently by repeatedly touching
SELECT
until the symbol flashes
and then adjusting the time as described above.
Touchpad SET (+) and SET (-)
Pressing touch pads momentarily increases or decreases time by one minute
Pressing touch pad increases or decreases the speed of time setting automatically.
Pressing touch pad constantly for 2 - 5 seconds (approx. 3 min/sec)
Pressing touch pad for more than 5 seconds (approx. 20 min/sec)
Within 5 seconds after selection of a function, the time of the signal volume can be set with
touchpad SET (+) or SET (-).
Touchpad SELECT
Pressing touch pad “SELECT” momentarily, the next following function is chosen.
Pressing touch pad “SELECT” permanently causes no change to function.
Pressing touch pad “SELECT” for more than 10 seconds an ACOUSTIC SIGNAL occurs and the
SELECT mode terminates automatically.
SET ACOUSTIC SIGNAL VOLUME
Step through the sequences of function until the display shows the chosen Acoustic Signal LI, L2,
or L3,the signal volume can be increased res. Decreased with Touchpad SET (+) or SET (-)
The acoustical feedback sounds in the selected volume.
L1 – low; L2 – medium; L3 – loud
MINUTE MINDER
To use it as a simple timer, touch SELECT
repeatedly until the symbol flashes, set the desired
time pressing
+
or
-,
after about 5 seconds the symbol stops flashing and the time starts to
decrease; to change the time set or zero it, press
+
or
-
.
When the time has run out, to deactivate the buzzer, touch any of the controls.
The maximum time that can be set is 99 minutes.
COOKING TIME
Setting end of cooking
Summary of Contents for FD6064WX
Page 24: ...TECHNICAL CHARACTERISTICS ...
