2 INSTALLER’S GUIDE
2.1 COOKER INSTALLATION
The Manufacturer declines any and all responsibilities for damages to things or injuries to
persons or animals deriving from incorrect installation or use of equipment.
The appliance has been certified by the Australian Gas Association and meets the requirements
of AS 4551 Domestic Gas Cooking Appliances.
This appliance shall be installed only by authorised personnel and in accordance with the
manufacturer’s installation instructions, local gas fitting regulations, municipal building codes,
water supply regulations, electrical wiring regulations, AS 5601 - Gas Installations and any other
statutory regulations.
The gas and electricity conditions are indicated in labels near the gas / electricity inlets.
The materials used in the cabinet to house the oven must be able to withstand temperatures
of 90ºC
Combustible materials, like curtains must be at the minimum distance of 500 mm
The furniture on the sides of the cooker, if higher than the cooking plan, must be at a minimum
distance of 150 mm from the side of the appliance - unless that surface is constructed of a
suitable non-combustible material for the entire length of the cooking surface.
Any horizontal surface situated within 200mm from the edge of any hob burner must be a
minimum of 10mm below the cooking surface or else comply with the above.
If the cooker is installed under a suspended element, this one must be placed at a minimum 700
mm of distance from the cooking plan.
The furniture over and beside the appliance must have a minimum clearance of 450 mm from the
cooking surface.
Zero clearance is permitted on side and rear adjoining surfaces provided the surfaces are
minimum 10mm below the hob.
Any rangehood above the cooker must be installed according to the manufacturer’s instructions,
with a minimum distance of 600 mm from the highest part of the hob to the rangehood.
The appliance must be installed in places with proper conditions relative to dimensions,
ventilation and exhaust of combustion products.
This appliance is not designed to be connected to an exhaust combustion products device.
Ventilation must be in accordance with AS5601 -
Gas Installations.
In general, the appliance
should have adequate ventilation for complete combustion of gas, proper flueing and to maintain
temperature of immediate surroundings within safe limits. It is recommended that a rangehood be
fitted above the appliance and exhaust to the outside.
Before installing the cooker, remove the protective plastic sheathing covering some metal parts.
Summary of Contents for FD6064WX
Page 24: ...TECHNICAL CHARACTERISTICS ...